little butane "torch". It worked fine for soldering ends onto chain and soldering bezel wire closed and even sweat soldering a tiny peach onto some textured silver I brought home with me. Then I tried to remove a part I had soldered onto some copper incorrectly and, because I used hard solder originally, it took ages. Only slightly daunted, I tried to ball the ends of some heavy wire... and tried and tried. Total failure. The ends of the wire look a little mushy, that's it. Finally, I pulled over a stool, sat down, and decided to finish texturing a piece of silver I'd started reticulating at PV. I held the torch on that sucker for a good three minutes and only managed to get the thinnest corner red-hot, which isn't hot enough. Feh.You know what this means, right? I have to buy a bigger torch. Normally, I would celebrate the opportunity to buy more tools, but a torch presents some problems. My studio is on the third floor, but I solder in the kitchen (first floor) because I like the fact that there are fire-proof surfaces to work on and a killer vent over the stove to deal with fumes. That's where I run the kiln for PMC and enameling, too. I don't really like the idea of having a tank of acetylene or propane on the third floor in what is essentially a spare bedroom. (No bed anymore, just acres of jewelry-making supplies.) Rick Marshall said it's actually illegal to have acetylene in the house. So what do I do? The garage is a shell with no electricity, so that's not an option. The basement is damp, moldy, and stinky, so that's definitely not an option. Time for some research. In the meanwhile, it's little tiny bits of easy solder for me. Feh.
